Hi, thanks for clicking on this thing. This is a 3D-printed holder for GPS and Action cam mount, made for the Eachine Tyro109. I remixed it from someone else's thing and made some improvements. Improvements from previous version of the person I remixed: - Higher camera angle compatibility. (the old version was only able to film at a limited angle) - Stronger model because the old version was fragile. - Easier to print. How to mount (assuming you already soldered the GPS cables): 1. With the top carbon plates take off the screws. (Do not rmove the plates because the mount will lay on them) 2. Put the mount on the plates and screw them on. You might have to apply some pressure but it should be quite easy to do. 3. Done!